My sand filtering is running from high pressures

The actual backwashing instructions inside your Owner’s Manual. The particular sand bed may be clogged with mineral deposits that will certainly not backwash away. A few calcium based chlorines and other option sanitizers will construct up within your fine sand bed, and will demand more frequent backwashing and changing involving the sand.

Before you decide to replace all the particular sand in your filter, try eliminating approximately 1″ of the top coating of the fine sand, replace with typically the exact level of fine sand you removed. Standard life span in the sand is about 4 – a few years.

You may well have to clear your filter method using a special filtration system cleaner, please call up Blue Haven Private pools & Spas with regard to more information.

Check to see if there is a closed or even partially closed device along your come back piping, open the valve.

Your pump motor may be also small to give sufficient flow for proper backwashing. The filter will perform, but a lower design flow level will cause your body to backwash incorrectly. Check the end result from the pump to be able to be sure that this equals your filter’s design flow rate. Replace Sandfilteranlage in case it is too small.

My sand filter is running inside of short series

Improper backwashing could be the reason. Always backwash till the water operates clear in the valve’s sight cup, usually about two minutes.

You might have live algae causing the filtering to clog. By simply testing the water balance using an evaluation kit and very chlorinating, you need to resolve this problem.

There exists sand at typically the bottom in the pool area

The sand a person are using may be too small, that can go through the particular filter system, well then back into typically the pool. Remove the particular sand and change it using the proper grade of crushed stone – #20 Silica or 45-55mm pool sand.

Your pump motor may be too large for your filtration system. During backwashing the particular pressure can cause typically the sand to increase large enough to flood into the standpipe, allowing sand to flow back straight into the pool. Recommend to your User’s Manual for typically the correct amount of sand to your filter.

There could become a loose spectrum of ankle located at the particular bottom of your current filter. Tighten virtually any loose laterals, replace if broken.

Most calcium based chlorine, both powder or tablets, contain coming from 30 – 35% of what will be called inert materials. This is calcium supplement residue or dust particles, which many swimming pool owners mistake intended for sand. You can confirm this by simply following these steps: Throughout vacuuming, make use of a side vac and rod. As the vac head approaches, the sand will put on the bottom level, and will enable itself to become picked up. Most calcium mineral residue will scatter away from vac brain as you try to pick it up.